“Green dry cutting” for CBN cutting tools
June 06, 2015
Dry cutting which means machining without coolant, is for protecting the social environment and lower the machining cost. Leadingtech Diamond factory’s CBN inserts could used with dry machining, and the performance (cutting life and surface finish) is same or better when compare with wet machining as customer’s feedback.
As machined without coolant, the machining cost could be lower at about 15%,it could widely used in the application of: brake rotors, brake drums, cast iron rolls, Mn steel rolls, engine block, gears, fly wheel and so on. And the above application are Leadingtech Diamond factory’s mature points.
Leadingtech Diamond will do its best to develop the economic and environmental machining method for the mechanical industry.